|
OVERSIGHT 1. FORGETTING TO CHECK AIR PRESSURE
Always check your air pressure, especially before a long trip. The best time to assess air pressure is when your tyres are cool. That is, at least three hours after your vehicle has been stopped or before it has been driven for one km.
OVERSIGHT 2. IGNORING THE PULL-EFFECT
Is your car pulling to the left or the right? Or perhaps your tyres appear to be worn only on one edge? Wheel alignment should be checked every 10 000 km’s or the moment this pull-effect occurs. Poor wheel alignment is a hazard to your road safety. Keeping your wheels aligned will prevent tyre wear and increase fuel mileage by reducing road friction and improve your vehicle’s handling.
OVERSIGHT 3. DISOBEYING THE TREAD RULE
It’s important to remember that the minimum tread on a passenger vehicle must be at least 1mm, by law. If the tread on your passenger vehicle’s tyres are below the minimum it means that the vehicle is unroadworthy and may not be driven on public roads.
OVERSIGHT 4. SHORT TRIPS ON NEW TYRES
Remember, when fitting your new tyres it is highly advisable to run them in by driving at a moderate speed for at least the first 200-300 kms, in order to roughen the tread surface. Only then will the tyres reach their full performance potential.
OVERSIGHT 5. NEGLECTING THE NITROGEN OPTION
Did you know that tyres inflated with nitrogen run between 10% and 15% cooler? Therefore tread life is extended, and your tyres also don’t lose pressure as quickly as those filled with air. Since Nitrogen is the preferred tyre gas used in motor racing and Military Aircraft tyres, it is certainly a safe tyre gas. If you are already using Nitrogen in your tyres, then keep doing so. If not, you may want to consider this as a preferred option.
OVERSIGHT 6. AVOIDING THE INFLATION RULE
Under-inflated tyres will negatively affect the handling of your vehicle: your tyres wear quicker and your fuel consumption will be higher. Over-inflated tyres will cause premature tyre wear and result in a completely harsh ride. Make sure that you use the manufacturer’s recommended air pressure, which can be located in your owner’s manual of your vehicle. If you still have your original wheels & tyres, stick with your original manufacturer’s recommendation. If you’ve changed sizes, then inflate at the recommended air pressure by your wheel & tyre specialists.
OVERSIGHT 7: RUNNING ON RUN-FLAT
Run-flat tyres should not be repaired. The reason for this is that the construction, strength and safety is severely compromised once you drive on a flat run-flat tyre. These tyres are merely beneficial in getting you to a place of safety after damage to the tyre has occurred. Damage is not always visible to the naked eye, so although the tyre looks fine, it in fact could be totally unsafe. If you are still driving with your run-flat tyres after they have already been run flat, you should have them replaced immediately. For a personal consultation on your wheel & tyre requirements, locate your nearest Tiger Wheel & Tyre at www.twt.to. For your fitment convenience Tiger Wheel & Tyre has now opened seven new stores: Silver Lakes, Montana, Strijdom Park, Greenstone, Ballito, Welkom and Bloem Mega Park.
BACK TO PRESS RELEASES
| 
